SEM Products 15093 Light Buckskin Color Coat User Manual

ઉત્પાદન ઓવરview

SEM Color Coat is a specialized elastomeric coating designed to restore or change the color of most vinyl surfaces, flexible and rigid plastics, carpet, and velour. This product is not a dye; it is a fade-resistant, flexible, and permanent coating.

It is formulated to provide a durable finish that integrates with the material, offering a renewed appearance without cracking or peeling when properly applied.

તૈયારી અને સેટઅપ

Proper surface preparation is crucial for optimal adhesion and durability of SEM Color Coat. Follow these steps carefully:

સપાટી સફાઈ:

• For Vinyl: Use SEM Soap (Part No. 39362) followed by Vinyl Prep (Part No. 38343) or Zero VOC Surface Cleaner (Part No. 40404).
• For Plastic: Apply an appropriate adhesion promoter. Do not use more than one product on the same job. Recommended products include Plastic Adhesion Promoter (Part No. 38363) or XXX Adhesion Promoter (Part No. 7723).

Ensure the surface is clean, dry, and free of any contaminants like grease, oil, or silicone before application.

સંચાલન સૂચનાઓ (એપ્લિકેશન)

Once the surface is prepared, proceed with the application of SEM Color Coat:

1. શેક કેન: Shake the aerosol can thoroughly for at least one minute after the mixing ball begins to rattle. Continue shaking periodically during application.
2. Application Distance: Hold the can approximately 6-8 inches (15-20 cm) from the surface to be coated.
3. Apply Light Coats: Apply multiple light, even coats. Avoid applying heavy coats to prevent runs or uneven coverage.
4. કોટ્સ વચ્ચે સૂકવવાનો સમય: Allow 5-10 minutes of drying time between each coat. Apply additional coats until the desired hiding and color depth are achieved.

For detailed information, refer to the RAP-1 or Technical Data Sheet available from SEM Products.

જાળવણી

Once applied and fully cured, SEM Color Coat is a durable and fade-resistant finish. To maintain its appearance, clean the coated surface with mild soap and water. Avoid harsh abrasives or strong chemical cleaners, as these may damage the coating.

મુશ્કેલીનિવારણ

Most application issues can be prevented by following the preparation and application instructions carefully. If issues arise:

• નબળી સંલગ્નતા: Often caused by inadequate surface cleaning or improper use of adhesion promoter. Ensure surfaces are thoroughly cleaned and prepped as per instructions.
• Uneven Finish/Runs: Typically results from applying coats too heavily or not allowing sufficient drying time between coats. Apply lighter, multiple coats.
• રંગ મેળ ખાતો નથી: Ensure the correct product color was selected for the intended application.

For persistent issues, consult the SEM Products technical data sheet or contact customer support.

વિશિષ્ટતાઓ

સલામતી માહિતી

DANGER: EXTREMELY FLAMMABLE AEROSOL. PRESSURIZED CONTAINER. MAY BURST IF HEATED. HARMFUL OR FATAL IF SWALLOWED. VAPOUR HARMFUL. CAUSES SERIOUS EYE IRRITATION. CAUSES SKIN IRRITATION.

Read all cautions on the back panel and product safety data sheet before use.

સામાન્ય સાવચેતીઓ:

• ગરમી, તણખા, ખુલ્લી જ્વાળાઓ અને ગરમ સપાટીઓથી દૂર રહો. ધૂમ્રપાન નિષેધ.
• દબાણયુક્ત કન્ટેનર: ઉપયોગ કર્યા પછી પણ વીંધશો નહીં કે બર્ન કરશો નહીં.
• Wear protective gloves, protective clothing, eye protection, and face protection.
• સંભાળ્યા પછી સારી રીતે ધોઈ લો.
• Store locked up. Keep cool. Protect from sunlight. Do not expose to temperatures exceeding 50°C (122°F).
• Dispose of contents/container in accordance with local, regional, national, and international regulations.

પ્રાથમિક સારવાર:

• જો આંખોમાં: થોડી મિનિટો સુધી પાણીથી સાવધાનીપૂર્વક કોગળા કરો. કોન્ટેક્ટ લેન્સ દૂર કરો, જો હાજર હોય અને કરવું સરળ હોય. કોગળા ચાલુ રાખો.
• જો શ્વાસ લેવામાં આવે તો: Supply fresh air. Consult a doctor if case of complaints.
• જો ત્વચા પર હોય તો: Wash with water and soap and rinse thoroughly.
• જો નિસ્તેજ કરવામાં આવે તો: Do NOT induce vomiting. Consult a doctor immediately.

WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects.

For more detailed information, refer to the Safety Data Sheet (SDS) for this product.

આધાર માહિતી

For further assistance, technical data sheets, or product inquiries, please contact SEM Products, Inc.:

SEM PRODUCTS, INC.
રોક હિલ, SC 29730
ફોન: 800-831-1122

અધિકારીની મુલાકાત લો website for more information on Color Coat aerosols: www.semproducts.com/color-coat-aerosols/